Tattoo-Me Henna Paste

Directions for Usage:
1. In a cup of hot water, drop your henna paste bottle for 5 minutes.
2. Shake well
3. Remove cap
4. Shake contents toward tip
5. Squeeze the bottle to dispense on skin
6. Allow to dry for 1 to 2 hours (the paste is usually dry within 30 minutes). This allows enough time for your skin to absorb the active ingredient in henna.
9. Let the paste fall off by itself to have a beautiful henna tattoo. Tattoo will first appear orange and then darken within 24 to 48 hours.

If needed, apply baby oil or vaseline on henna tattoo area before washing. Then wipe it with a napkin after the wash. This will prevent your design from fading prematurely. It is advised to do this for the first 2 days.

For Best Results:
Wash skin before applying paste. Once the henna paste is relatively dry, dab lemon juice on the dried paste to wet it again. Let it dry for another 1-2 hours. This makes your henna tattoo get a darker imprint. Henna is a product of the sun. It is best activated by heat and serves as a cooling agent.


Tattoo-Me Henna Kit

Directions for Usage:
1. Put powder in a paper cup or a plastic bag (provided in your kit).
2. Pour lemon juice gradually as you mix powder to paste.
3. Try to attain a "tooth paste consistency" by thoroughly mixing the paste.
4. Then add Eucalyptus oil mixture to the paste (1 to 2 hrs later). This will make your paste thinner and more fluid.
5. Pour the mixed paste into applicator cone or platic bottle if provided.
6. Twist top after pouring done. You're then ready to Tattoo-You !!!

Need Help? Click here to post your questions.

For Best Results:
Wash skin before applying paste. Rub a little bit of eucalyptus oil on tattoo area, to open pores. Once the henna paste is relatively dry, dab a little lime or lemon juice to make the henna leave a darker imprint. Henna is a product of the sun. It is best activated by heat and serves as a cooling agent.


A note on Mixed vs. non-Mixed Henna Paste:
Most Henna artists like to mix henna powder "fresh" before applying it. It makes them feel as their mixture gets better results. We do feel the same way. However, the mixed henna paste warmed up can give just as good a result as the "freshly" mixed henna. The way we do it is this way: If you do not have the time and patience to mix your henna, then warm up the mixed paste. If you do, you'll have just as much fun mixing it as you would applying it.

Usage Directions for Tattoo-Me Henna Kits:
Pour henna powder from vial into plastic pouch. Add lemon juice, 4-5 table spoons for a 15g vial (in all Tattoo-Me Henna Kits, except 5)	Mix thoroughly to make the paste reach a toothpaste consistency. Let the paste sit for 2-4 hours at this point
Add a few drops of Eucalyptus Oil, 4-5 drops	Keep mixing to squeeze and smoothen clumps
Wrap the plastic bag in a paper towel or napkin. Let sit for a minimum of 4-6 hours for maximum dye release (up to 12 hours at cold temperatures)	When the paper towel is orange, your henna paste is ready to draw with

You can apply your henna paste with either a plastic bottle or with a cone, here are directions for both. If you have ordered a henna paste products from us, a plastic cone has been included for you to try this authentic way of henna application.